Ace ACE-3105, Инструкция по установке и эксплуатации

Страница: 181 / 418

Installation and Operation Manual Chapter 4 Configuration
ACE-3105, ACE-3205 Ver. 5.2 Configuring for Operation 4-91
Parameter Description Possible Values
VCI VCI of the PVC connected to the router
interface. Not available for Ethernet and PW
interface type.
Note: A router interface with the same
VPI/VCI as an existing VC XC on the same
port cannot be configured.
32 – 65535
Default: 32
Out TD Traffic descriptor of the PVC connected to
the router interface. Not available for
Ethernet and PW interface type.
Note:
• A traffic descriptor (TD) must be
configured before it can appear on the
menu.
• The descriptor's rate cannot be higher
than the port's output rate.
• A TD with the CBR-CES service category
cannot be used.
1 – 99999
Default: 1
OD OAM descriptor of the PVC connected to the
host interface. Not available for Ethernet
and PW interface type.
Note: An OAM descriptor (OD) must be
configured before it can appear on the
menu and it must be defined as end-to-end
or segment.
1 – 256
Default: 2
LLC/SNAP
Encapsulation LLC/SNAP encapsulation used with AAL5
frame. Bridged PDU
Routed PDU
Default:
• ADSL2+ and
IMA over SHDSL
•
Remaining scenarios:
Routed PDU
VLAN tagging Indicates whether a VLAN tag is to be
inserted into the TX (receive) frames.
Available only for Ethernet interface or a
VCL interface (already created in the VCL
Interface menu). Enable
Disable
Default: Disable
VLAN ID Identifies the VLAN that will be carried on
the VLAN tag. Available only if VLAN tagging
is enabled (see above). 0 – 4094
Default: 0
VLAN priority Indicates the priority bit value of the VLAN
that will be carried on the VLAN tag.
Available only if VLAN tagging is enabled
(see above). 0 – 7
Default: 0