ABB ACS350 Series, Руководство пользователя

Страница: 65 / 314

Control panels
65
Copy mode
The Basic Control Panel can store a full set of drive parameters and up to three user
sets of drive parameters to the control panel. The control panel memory is non-
volatile.
In the Copy mode, you can do the following:
• Copy all parameters from the drive to the control panel (uL – Upload). This
includes all defined user sets of parameters and internal (not adjustable by the
user) parameters such as those created by the ID Run.
• Restore the full parameter set from the control panel to the drive (dL A –
Download All). This writes all parameters, including the internal non-user-
adjustable motor parameters, to the drive. It does not include the user sets of
parameters.
Note: Only use this function to restore a drive, or to transfer parameters to
systems that are identical to the original system.
• Copy a partial parameter set from the control panel to a drive (dL P – Download
Partial). The partial set does not include user sets, internal motor parameters,
parameters
9905 … 9909 , 1605 , 1607 , 5201 , nor any group 51 EXT COMM
MODULE and 53 EFB PROTOCOL parameters.
The source and target drives and their motor sizes do not need to be the same.
• Copy USER S1 parameters from the control panel to the drive (dL u1 – Download
User Set 1). A user set includes group 99 START-UP DATA parameters and the
internal motor parameters.
The function is only shown on the menu when User Set 1 has been first saved
using parameter
9902 APPLIC MACRO (see section User macros on page 94 )
and then uploaded to panel.
• Copy USER S2 parameters from the control panel to the drive (dL u2 – Download
User Set 2). As dL u1 – Download User Set 1 above.
• Copy USER S3 parameters from the control panel to the drive (dL u3 – Download
User Set 3). As dL u1 – Download User Set 1 above.
• Start, stop, change the direction and switch between local and remote control.