VIGIL Software v8.8 User Manual |
VISIX V-Series All-in-One Cameras
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
73
NETWORK LOSS
Steps:
1).
Opening the
Setup Tab>Event Configuration
drop-down menu and clicking the
Network Loss
link will open the
Network Loss
settings page.
Figure 7-32
: Setup Tab – Event Configuration Menu – Network Loss Settings
2).
From the
Network Loss
settings page, a user may configure the following network signal loss
settings:
Stream Setting
Description
Check Ethernet
Connectivity
Enable the camera to check for Ethernet (physical) connectivity.
Check Ping
Response
Enable the camera to check for network connectivity, via network ping.
Interval
Configure the time interval in between checks/pings.
Host Address
Enter the address of the device you would like the camera to ping. When this
device cannot be reached/ a ping response is not received, the camera will fall
into a network loss state.
3).
Click
Apply
to save changes to network loss settings.
