VIGIL Software v8.8 User Manual |
VISIX V-Series All-in-One Cameras
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
69
EVENT SOURCE (TRIGGERS) TAB – ADDING/MODIFYING EVENT RULE
Steps:
1).
Under the
Event Source
tab of the
Add/Modify Event Rule
form, the following event trigger
settings can be configured:
Event Source
(Trigger) Setting
Description
Motion Detection
Enable the rule to trigger based off of Motion Detection. Click the
Go to Motion
Detection Configuration
to edit motion detection settings.
VCA Source
Enable to rule to trigger based off of a VCA (video analytics) source. (i.e. tripwire,
customer not present, etc…) When this box is checked, an additional form will deploy
allowing the user to pick specific VCA elements as trigger criteria (pictured below).
Figure 7-28
: Setup Tab – Event Configuration Menu – Event Rules Settings – Event Source Tab - VCA Source
Settings
Available criteria will vary based on active VCA rules.
A trigger mode can also be chosen. Select
Rising Edge
to trigger an event at the onset
of a VCA rule being triggered. Select
Falling Edge
to trigger an event at the conclusion
of an event being triggered (latched). Select
Both
to trigger an event rule regardless
of the state of a VCA event.
Click
Go to VCA Configuration
to edit video analytics rule settings.
Face Detection
Enable the rule to trigger based off of facial recognition of a specific person.
Click
Go to Face Detection Configuration
to edit facial recognition settings.
Network Loss/Detect
Enable the rule to trigger whenever network signal loss is detected.
Click
Go to Network Loss Configuration
to edit network loss settings.
Network Setting
Changed
Enable this rule to trigger whenever a network setting change is detected.
Storage Error
Enable the rule to trigger whenever a storage error is detected.
Recurrence
Enable the rule to trigger on a reoccurring basis. When selected, the user will be able
to assign a time interval for the reoccurring trigger.
Schedule
Enable the rule to trigger based on a schedule. The event rule will remain active only
during the scheduled times.
Click the
Go to Schedule Configuration
link to open the
Schedule
settings and
configure a schedule as needed. The
Schedule
event source
option will not be
available until schedule settings have been properly configured.
