VIGIL Software v8.8 User Manual |
VISIX V-Series All-in-One Cameras
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
4
Safety Instruction
These instructions are intended to ensure that the user can use the product correctly to avoid danger or
property loss.
The precaution measure is divided into ‘Warnings’ and ‘Cautions’:
WARNING
:
Serious injury or death may be caused if any of these warnings are neglected.
CAUTION:
Injury or equipment damage may be caused if any of these cautions are neglected.
WARNING:
Please adopt a power adapter which can meet the safety extra low voltage (SELV) standard when
possible, and source with 12 VDC or 24 VAC (depending on models) according to the IEC60950-1
and Limited Power Source standard. Before applying power to the camera, check the power
source to ensure that it is within the specifications
If the product does not work properly, please contact your dealer or the nearest service center.
Never attempt to disassemble the camera yourself. (We shall not assume any responsibility for
problems caused by unauthorized repair or maintenance.)
To reduce the risk of fire or electrical shock, do not expose this product to rain or moisture unless
it is an exterior/weatherproof model. Please do not install the camera in a place exposed to direct
sunlight. Do not operate the camera in environments beyond the specified temperature. Refer to
the VISIX V-Series All-in-One Hardware and Installation manual for environmental conditions and
limitations of your particular camera model.
This installation should be made by a qualified service person and should conform to all the local
codes.
Please install blackout equipment into the power supply circuit to prevent footage and data loss.
Please make sure that the ceiling can support more than 50(N) Newtons of gravity if the camera is
fixed to the ceiling.
CAUTION:
Make sure the power supply voltage is correct before using the camera.
Do not drop the camera or subject it to physical shock.
Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a bit of
ethanol and wipe it gently. If the camera will not be used for an extended period of time, put on the
lens cap to protect the sensor from dirt.
Do not aim the camera lens at the strong light such as sun or incandescent lamp. The strong light
can cause fatal damage to the camera.
The sensor may be burned out by a laser beam, so when any laser equipment is being used, make
sure that the surface of the sensor not be exposed to the laser beam.
Do not place the camera in extremely hot, cold temperatures (the operating temperature should be
between -30°C ~ 60°C, or -40°C ~ 60°C if the camera model has an “H” in its suffix), dusty or damp
environment, and do not expose it to high electromagnetic radiation.
To avoid heat accumulation, good ventilation is required for a proper operating environment.
