Chapter 10 Routing
USG20(W)-VPN Series User’s Guide
233
Figure 153
Configuration > Network > Routing > Policy Route > Add/Edit (IPv6 Configuration)
The following table describes the labels in this screen.
Table 91
Configuration > Network > Routing > Policy Route > Add/Edit
LABEL
DESCRIPTION
Show Advanced
Settings / Hide
Advanced Settings
Click this button to display a greater or lesser number of configuration fields.
Create new Object
Use this to configure any new settings objects that you need to use in this screen.
Configuration
Enable
Select this to activate the policy.
Description
Enter a descriptive name of up to 31 printable ASCII characters for the policy.
Criteria
User
Select a user name or user group from which the packets are sent.
Incoming
Select where the packets are coming from; any, an interface, a tunnel, an SSL VPN, or
the USG itself. For an interface, a tunnel, or an SSL VPN, you also need to select the
individual interface, VPN tunnel, or SSL VPN connection.
Source Address
Select a source IP address object from which the packets are sent.
Destination Address
Select a destination IP address object to which the traffic is being sent. If the next hop
is a dynamic VPN tunnel and you enable
Auto Destination Address
, the USG uses
the local network of the peer router that initiated an incoming dynamic IPSec tunnel as
the destination address of the policy instead of your configuration here.
Summary of Contents for ZyWall USG20-VPN
Page 17: ...17 PART I User s Guide ...
Page 18: ...18 ...
Page 99: ...99 PART II Technical Reference ...
Page 100: ...100 ...
