ZyXEL Communications ZyWall USG20-VPN, User Manual

Page: 230 / 683

Chapter 10 Routing
USG20(W)-VPN Series User’s Guide
230
Figure 151
Configuration > Network > Routing > Policy Route
The following table describes the labels in this screen.
Table 90
Configuration > Network > Routing > Policy Route
LABEL DESCRIPTION
Show Advanced
Settings / Hide
Advanced Settings Click this button to display a greater or lesser number of configuration fields.
Enable BWM This is a global setting for enabling or disabling bandwidth management on the USG.
You must enable this setting to have individual policy routes apply bandwidth
management.
IPv4 Configuration /
IPv6 Configuration Use the IPv4 Configuration section for IPv4 network settings. Use the IPv6
Configuration section for IPv6 network settings if you connect your USG to an IPv6
network. Both sections have similar fields as described below.
Use IPv4/IPv6 Policy
Route to Override
Direct Route Select this to have the USG forward packets that match a policy route according to
the policy route instead of sending the packets directly to a connected network.
Add Click this to create a new entry. Select an entry and click Add to create a new entry
after the selected entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can
modify the entry’s settings.
Remove To remove an entry, select it and click Remove . The USG confirms you want to
remove it before doing so.
Activate To turn on an entry, select it and click Activate .
Inactivate To turn off an entry, select it and click Inactivate .
Move To change a rule’s position in the numbered list, select the rule and click Move to
display a field to type a number for where you want to put that rule and press
[ENTER] to move the rule to the number that you typed.
The ordering of your rules is important as they are applied in order of their
numbering.
# This is the number of an individual policy route.