ZyXEL Communications P-320W v3, User Manual

Page: 75 / 262

Chapter 5 Wireless Client Mode
P-320W v3 User’s Guide
75
The following table describes the labels in this screen.
Table 34 Summary: DHCP Table
LABEL DESCRIPTION
Client AP
Function Select Enable to use your P-320W v3 as a wireless client and connect to
an existing AP.
Select Disable to use your P-320W v3 as a router or an access point if the
network to which you are connecting already has a router. Your P-320W v3
is configured as a router/access point by default.
SSID Enter the name of the access point to which you are connecting.
You can also copy the SSID of the access point to which you want to
connect by clicking
copy in the list of access points that appears when you
click Scan AP .
Channel Select the channel of the access point to which you are connecting.
Note: To comply with US FCC regulation, the country selection
function has been completely removed from all US models. The
above function is for non-US models only.
MAC Address Enter the MAC address of the access point to which you are connecting.
Roaming
Threshold Select the signal strength threshold between the wireless client and the
access point.
When the signal strength between the two devices goes below the value
you set in this field, the wireless client searches for and connects to
another access point within the roaming threshold.
Encryption
type Select WEP if you want to secure the wireless connection.Otherwise,
select No Security .
WEP key
length This field appears when you select WEP as the security type.
Select either 64 bit or 128 bit as the key length for your WEP key.
WEP Key
Mode This field appears when you select
WEP
as the security type.
Select either HEX or ASCII as the key length for your WEP key.
WEP Key 1 to
4 This field appears when you select WEP as the security type.
Select which WEP key you want to use for your wireless connection. By
default, the P-320W v3 uses
WEP key 1 .
Scan AP Click this to view a list of available access points to which you can connect.
SSID This is the SSID of the access point.
Channel This is the channel of the access point.
MAC Address This is the MAC Address of the access point.
RSSI This is the RSSI or signal strength of the access point.
Encryption
type This is the encryption type of the access point.
copy Click this to copy the SSID of the access point to the SSID field.
Apply Click Apply to save your changes back to the P-320W v3.
Reset Click Reset to reload the previous configuration for this screen.