Chapter 3: Configuration and commissioning
ZP2 Series Installation Manual
51
4. Select Reports from the Main menu.
5. Select Event log, and then select Backup.
6. Follow the on-screen instructions.
7. Press F2 (Exit) to exit.
8. Remove the flash drive as described in “Removing a USB device” on page
44.
Note:
If your flash drive is not recognized by the control panel, reformat it as
FAT32 from a PC and try again. If the problem persists, try a different flash drive.
Figure 21: USB connectors on the control panel PCB
1. USB connectors
Saving reports
Select Save report to save a report. Reports are saved to a USB flash drive (not
supplied) in XML format and can be viewed with the configuration utility PC
application.
To save a report:
1. Open the control panel cabinet door.
2. Insert a USB flash drive into either of the USB connectors.
3. Close the control panel cabinet door.
4. Select Reports from the Main menu.
5. Select Save report, and then select ALL or the report to be saved.
6. Press F2 (Exit) to exit.
7. Remove the USB flash drive as described in “Removing a USB device” on
page 44.
Summary of Contents for ZP2 Series
