Ziton ZP2 Series, Installation Manual

Page: 72 / 148

Chapter 3: Configuration and commissioning
66 ZP2 Series Installation Manual
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Detector Dirty Warning
Select Det Dirty Warning to configure a detector contamination level, over which
the control panel report a condition for the device. The default setting is 80%.
To change the configuration:
1. Select Panel setup from the Main menu.
2. Select Other settings, and then select Det Dirty Warning.
3. Select Warn_L and enter the required contamination level.
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Load/Save configuration
Restoring the previous configuration
Select Restore configuration to restore the previous system configuration.
To restore the system configuration:
1. Select Panel setup from the Main menu, and then select Configuration.
2. Select Restore configuration and confirm your selection.
3. Press F4 (Enter), and then press F1 (Back).
4. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Loading and saving configuration files
Select Load configuration or Save configuration to load a system configuration
file from a USB flash drive or to save the current system configuration file to a
USB flash drive.
Note: If your flash drive is not recognized by the control panel, reformat it as
FAT32 from a PC and try again. If the problem persists, try a different flash drive.
To load a configuration:
1. Open the control panel door and insert the USB flash drive with the
configuration file into either of the USB type A connectors (see Figure 4 on
page 17). Close the control panel door.
2. Select Panel setup from the Main menu.