Ziton ZP2 Series, Installation Manual

Page: 96 / 148

Chapter 3: Configuration and commissioning
90 ZP2 Series Installation Manual
The default control panel output groups are shown below.
Note: This option is not available on repeater panels.
Table 51: Default output groups
Group number
Type Description
1 SND Sounder and supervised outputs.
301 PRG Nonsupervised relay outputs. These outputs are assigned
to this group during autosetup.
801 EXTIN Extinguishing device outputs. [1]
971 FR Fire routing outputs. This group is only available on
control panels with the corresponding fire routing controls.
981 FP Fire protection outputs. This group is only available on
control panels with the corresponding fire protection
controls.
991 ALARM [2] Outputs activated when the control panel is in alarm
status.
992 FAULT [2] Outputs activated when the control panel is in fault status.
993 DIS [2] Outputs activated when the control panel is in disable
status.
994 TEST [2] Outputs activated when the control panel is in test status.
[1] Extinguishing output groups are only activated with EN 54 type C alarm confirmation.
[2] These output groups are not configurable.
Configurable options for output groups are shown below.
Table 52: Configurable options for output groups
Option
Description
Group_n Configures the output group number
Type Configures the output group type
Control Enables or disables the output group
[BLANK] Output description
To configure a default output group:
1. Select Field setup from the Main menu, and then select Output groups.
2. Select Output groups.
A list of the available output groups is displayed. Press F3 (Search) to search
by group number. Press F4 (Delete) to delete an output group.
3. Select the output group to configure.
You cannot change the group number or output group type for a default
output group.