Ziton ZP2 Series, Installation Manual

Page: 67 / 148

Chapter 3: Configuration and commissioning
ZP2 Series Installation Manual 61
Email accounts
Select Email accounts to manage the email accounts for remote monitoring and
to configure the notifications sent to each email address. For correct operation,
TCP/IP and email server details must be configured (see “Email server” below).
Note:
Maintenance users are also able to modify settings for this service.
To manage email accounts:
1. Select Communications from the Main menu.
2. Select Email accounts, and then select the account to be edited (the default
names are Account 1, Account 2, etc.).
3. Check the notifications to include in the email: alarm events, fault events,
condition events, log events, or reports.
If no notifications are checked, the notification service is not activated.
4. Enter the email address associated with the email account.
5. Press F4 (Enter), and then press F1 (Back).
6. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Email server
Note:
These settings have no effect if direct email support is enabled in TCP/IP.
See “TCP/IP” on page 60.
Select Email server to configure the email server settings for sending configured
notification emails. IT support may be required to configure this option.
To configure the email server:
1. Select Panel setup from the Main menu, and then select Communications.
2. Select Email server.
3. Enter the Host (domain), IP address, and email address of the email server.
The Host name is optional.
4. If the email server requires SMTP authentication, enter the port, username,
and password.
5. Press F4 (Enter), and then press F1 (Back).
6. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
SNTP server
Select SNTP server to configure the Simple Network Time Protocol (SNTP)
server settings. SNTP is a networking protocol for clock synchronization.