Ziton ZP2 Series, Installation Manual

Page: 83 / 148

Chapter 3: Configuration and commissioning
ZP2 Series Installation Manual 77
To change the configuration:
1. Select Panel setup from the Main menu.
2. Select BMS Config.
3. Configure all required settings.
Initpan is only required when using Modbus in Zonepoint mode.
Zonepoint mode implements Modbus services for 32 networked fire panels
with consecutive addresses (for example, 1 to 32 if the address of the first
panel is defined as 001 in InitPan).
Zone mode implements Modbus services for 128 networked fire panels
(InitPan is not required).
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Field configuration
Use the Field setup menu to access the field configuration options shown below.
Table 39: Field configuration options
Option
Description
Autosetup Automatically configures installed loop devices to their default
settings.
Loop device configuration Configures installed loop devices or change default settings.
Zone configuration Configures zones.
Panel I/O configuration Configures control panel input and output functionality.
Output groups Configures output groups.
Activation configuration Configures output group delays and regional investigation time
options.
Loop class Configures the installation loop wiring Class (Class A or Class B).
Autosetup
Select Autosetup to automatically configure installed loop devices. Autosetup
assigns a default configuration for each device type detected.
To begin autosetup:
1. Select Field setup from the Main menu, and then select Autosetup.
2. Select the corresponding loop or All loops.
During the search the LCD displays the message “Autosetup in progress”.
When the autosetup is complete the list of detected devices is displayed.