Ziton ZP2 Series, Installation Manual

Page: 81 / 148

Chapter 3: Configuration and commissioning
ZP2 Series Installation Manual 75
Option Description Default value
Description Configures the description
Password Configures the network password
Period Configures the heartbeat period (in seconds) 60 s
Fails Configures the minimum number of consecutive
heartbeat failures required to indicate a
communication error with the central monitoring
station
03
To change the configuration:
1. Select Panel setup from the Main menu.
2. Select DACT config, and then select GPRS config.
3. Configure all required settings.
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Panel activation key
Note:
See your PAK registration guide for more details on how to register or
unregister purchased PAKs.
Select Panel Activ. Key to register or unregister panel activation keys (PAKs).
PAKs are used to extend the default functionality of the control panel - increasing
the network capability, enabling additional protocols, etc. A list of available PAKs
is shown in the table below.
Table 36: Panel activation keys
PAK
Description
2010-2-PAK-NET128 Increases the network capability to 32 nodes and 128 loops [1]
2010-2-PAK-NET256 Increases the network capability to 64 nodes and 256 loops [1]
2010-2-PAK-RMSDK Enables custom event reporting and command control using the
Edwards software development kit (SDK)
2010-2-PAK-RMOH Enables the Contact ID protocol over Ethernet
2010-2-PAK-RMBN Enables the BACnet protocol over Ethernet
2010-2-PAK-RMMB Enables the Modbus protocol over Ethernet
2010-2-PAK-900 Enables the 900 Series protocol
[1] The default network capability with no PAK installed is 32 nodes and 32 loops.