![background image](http://html1.mh-extra.com/html/yuchai/yc135/yc135_operation-and-maintenance-manual_3663100143.webp)
143
Decrease the tension:
G
REASE UNDER PRESSURE
Remove the grease from the strain crawl cylinder only as
shown in procedure below.
1. Open the top (1) then loosen the lubricator (2) gradually on the strain crawl
cylinder to realise the grease.
2. Turn the lubricator a maximum of one turn.
3. If the grease does not come out smoothly, move the machine backwards
and forwards.
4. Tighten the lubricator.
5. Travel the machine backwards and forwards to check if the track tension
has been achieved.
REPLACE RUBBER SHOES
M
ACHINE LIFTING
•
•
Two operators must carry out these operations. One
must travel the machine according to signal from the
other. The track tension cam be verified only when the
track is lifted.
•
Be careful do not low down the machine while the
operator is checking the tension.
G
REASE UNDER PRESSURE
Grease inside the adjusting mechanism is under high
pressure, if it coming out from lubricator point can
penetrate or hit your body causing injury or death. For this
reason:
•
•
do not loosen lubricator (1) more then one turn,
•
do not loosen any other part than lubricator.
What prepare:
•
Grease gun;
•
Steel pipe.
Summary of Contents for YC135
