Xicom XTS-200C, Operation And Installation Manual

Page: 48 / 168

MNC-0300-011 10 of 26 Revision H
Unpacking and Installation
Monitor and Control Connector
To externally control the amplifier a M&C interface is provided. The
connector is a 32-pin MIL style waterproof connector.
The Monitor and Control connector provides these interfaces for the use
of the customer:
•
COM1 — RS-232 Serial Port.
•
COM2 — RS-422/ RS-485 Serial Port.
•
Two sets of Form “C” Relay contacts for Summary Fault indication.
•
RF Inhibit Control.
•
24 VDC @ 100 mA maximum.
•
15 VDC for monitoring purposes only.
•
Hardware Address Select (digital SSAs only).
Monitor and Control Pinouts
Figure 4 shows the pin layout; Table 1 lists the pinouts for the typical
Digital Monitor and Control Connector on the Antenna Mount Power
Amplifier.
Figure 5 shows the pin layout and Table 2 lists the pinouts for the typical
Analog Monitor and Control Connector on the Antenna Mount Power
Amplifier.
Figure 4, Digital M&C Connector Pin Layout