Xicom XTS-200C, Operation And Installation Manual

Page: 154 / 168

MNC-0000-003 2 of 4 Revision B
Operation Addendum, SSPA M&C Termination Cable
Operation Addendum, SSPA M&C Termination Cable
Description
The SSPA is capable of operator interface through a controller or running
continuously in the last mode programmed. This is accomplished using a
specially configured termination cable (Xicom P/N 350-0716-002.)
The termination cable has been wired so that the SSPA will operate in an
unattended or standalone state.
Using the Cable
Refer to the chapter titled Operation . Program the SSPA to perform the
functions that you require. When you are satisfied that you have all the
functions setup properly, disconnect the Controller M&C cable from the
SSPA (J1) and replace it with the termination cable. The SSPA will now
operate unattended.
Termination Cable Wiring
Pin letter and signal names are shown in the table below.
The termination cable is wired as follows:
•
Pin h is jumpered to Pin Z.
•
Pin f is jumpered to Pin g
•
Pin Y is jumpered to Pin a.
The figure on page 3 shows the jumpers connected. The two views
illustrate the possible connector layout positions.
Pin Signal Name
a System Ground.
f +15 VDC Monitor and Optical Isolator Bias Supply.
g +5 to +15 VDC Input Supply to RF Inhibit Optical Isolator.
h Reboot Computer (connect Pin h to either Pin Z or Pin a
for normal operation.)
Y RF Inhibit (connect Pin Y to either Pin Z or Pin a to inhibit
RF.)
Z System Ground.