MNC-0500-010
28
Revision D
Solid State Power Amplifier Communication and Protocol
Clear RF Inhibit
Command Byte
: 'J'
Function
: RF drive to the SSPA is enabled.
Compatibility
: Attenuator required.
Set Attenuator
Command Byte
: 'K'
Parameter:
“XX.X” dB of attenuation OR
“IX.X” to increase attenuation by X.X OR
“DX.X” to decrease attenuation by X.X
Function
: Instantly sets the attenuator to the specified dB level. Use caution, as
sudden large changes to output power can damage the SSPA.
Response:
Resulting attenuation in XX.X dB. If the user specified an attenuation
value outside the attenuator’s range, the closest valid value will be used.
Note:
Use this to find max attenuation. For example, send {AK 99.9}. A typical
response would be {AK 30.0}, indicating a 30 dB attenuation range.
Compatibility
: Attenuator required.
Low RF Trip
Command Byte
: 'L'
Function
: Sets a Low RF trip point. If output power drops below the set point, an
alarm or fault is generated. By default the trip point is not enabled until this trip point is
set.
Parameter
: "AXXXX" to set an Alarm trip point, "FXXXX" to set a Fault trip point, “D” to
disable.
XXXX is the desired trip point in Watts.
Summary of Contents for XTS-200C
