Xicom XTS-200C, Operation And Installation Manual

Page: 130 / 168

THIS DOCUMENT IS THE PROPERTY OF XICOM TECHNOLOGY. REPRODUCTION OR RELEASE WITHOUT EXPRESS PERMISSION IS STRICTLY PROHIBITED.
XTS-200C, 5.85-6.425GHz, W/BUC
Document No. 305-0281-002 REV B Page 8 of 8
Appendix A
(cont.)
Requirements Spec
Paragraph
No
Test Description Test Condition
Min Max
Units Measured
Performance
Pass
or
Fail
3.2.5.1 Gain Small Signal
Note 2)
Input Power P
in
to provide
P
out
=P
rated
-10 dB at midband
Freq = 6.1375 GHz
STD
Output freq swept
from 5.85 to 6.425 GHz 65 75 dB
See attached
plot
Pass
Fail
3.2.5.2 Gain Flatness over 575MHz
Note 2)
STD
Output freq swept
from 5.85 to 6.425 GHz
N/A 2 .5 dB
See attached
plot
Pass
Fail
3.2.5.3
Gain Flatness over 40 MHz
Note 2)
STD
Output freq swept
from 5.85 to 6.425 GHz
N/A 1.0 dB
See attached plot
Pass
Fail
3.2.5.4 Gain Slope
Note 2)
STD
Output freq swept
from 5.85 to 6.425 GHz
NA ± 0.04 dB/MHz
See attached plot
Pass
Fail
3.2.5.5 Gain Control
Note 2) and Set Attn to 20 dB
STD
Output freq swept
from 5.85 to 6.425 GHz
20 N/A dB
Pass
Fail
See attached plot
3.2.16 Spurious Signals
(Inband discrete) maximum
Note 2)
Adjust P
in
for P
rated
-3 dB
STD
P
out
= P
rated
-3dB
30 Hz to 10 kHz
10 kHz to 500 kHz
> 500 kHz
-37
-20(1.5+log(f)) - 13
-72
dBc
dBc
dBc
Span = 2 kHz
Span = 20 kHz
Span = 200kHz
Span = 2 MHz
Span = 20 MHz
Span = 200 MHz
Pass
Fail
NA 1600 VA
Pass
Fail
STD
VAC= 90 , 60 Hz
P
out
= P
rated
0.95 N/A
Pass
Fail
NA 1600 VA
Pass
Fail
3.2.19 Prime Power
Power Factor
5min after turn on
STD
VAC= 264 , 60 Hz
P
out
= P
rated 0.95 N/A
Pass
Fail
STD
Set drive level for 0 dBm
at sample port.
Record output power at
flange for freq below :
Record Output
Power
(Coupling
Factor)
Freq = 5.85 GHz
N/A N/A dB
Freq = 6.1375 GHz
N/A N/A dB
3.2.18
Sample Port Coupling
Freq = 6.425 GHz
N/A N/A dB
Tested by : _______________ Date:________ Verified by : ________________ Date: _______