Xicom XTS-200C, Operation And Installation Manual, Page: 81 / 168

MNC-0500-010 9 Revision D
Solid State Power Amplifier Communication and Protocol
Flow control options should be set to "none."
•
SSPAs support 8/1 or 7/1, but not 8/2, etc.
•
The default communication parameters are 9600 baud, N/8/1, unless
otherwise requested.
•
Parameters are selected using a remote interface.
Table 1, Standard Packet Format
Start
Byte
Address
Byte
Message
Byte
Parameters
as Required
End
Byte
Check
Byte
Table 2, Packet Format (Redundant Controller — XTSC-100 Family)
Start
Byte
Address
Byte
Device
Selection
Byte
Message
Byte
Parameters
as Required
End
Byte
Check
Byte
CRLF
(Ethernet
only)
Table 3, Start Byte, End Byte, & Check Byte
Protocol
Packet
Type
Accept/
Reject
Start
Byte End
Byte
Check
Byte
Ethernet
Terminator
Byte
Printable Message (ASCII){ (ASCII)}
Response
Message
Accepted
or Rejected
{ } “Base 95”
13
(CR)
Message STX ETX
Non-Printable Response
Message
Accepted
ACK ETX
“Exclusive
OR” 13
(CR)
Message
Rejected
NAK ETX