Xerox Wide Format 6705 System, User Manual

Page: 254 / 363

8
Problem Solving
8.5 Problems during Copying
254
8.5 Problems during Copying
This section describes how to troubleshoot problems during copying.
Symptom Check Remedy
The document is
not correctly fed. Is the document too small? The minimum size of the document that can be loaded is 176
(width) x 210 (length) mm.
Refer

Refer to "Usable Originals" (p. 72).
The output image
on the media fed
from the bypass
(manual) feed
table is
misaligned. Is the position of the media
loaded on the bypass (manual)
feed correct? Load media in the correct position.
Refer

Refer to "Loading Cut Sheet Paper (Bypass)" (p.
48).
The corner of the
copied document
is dog-eared. Is the document curled? Flatten the curled document before loading it.
Document is not
copied at the
desired size. Did you select the document size
series properly? Set the media size series properly in accordance with the actual
original size.
Refer

Refer to "Auto Detect" (p. 113).
Did you select the media size
series properly? Set the media size series properly in accordance with the actual
media size.
Refer

Refer to "Loading/Replacing Paper" (p. 45).
Is the document placed correctly? Correctly load the document.
Refer

Refer to "Step 3 Starting the Copy Job" (p. 80).
Is the document guide set
properly? Set the document guide correctly.
Refer

Refer to "Step 3 Starting the Copy Job" (p. 80).
Is the document bent? Smoothen the surface of the document before loading.
Refer

Refer to "Step 3 Starting the Copy Job" (p. 80).