Xerox Document Centre 480 ST, System Administration Manual

Page: 75 / 322

Xerox Document Centre System Administration Guide Page 10 - 1
10
. Windows
2000
LP
R a
n
d
I
P
P
10
.
Wi
ndow
s 2
000
L
P
R
an
d
I
PP P
rin
ti
n
g
10. Windows 2000 LPR and IPP
Printing
Before you Start
NOTE Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If your DHCP server will
provide host name, IP address, Gateway address, and Subnet Mask,
the Document Centre TCP/IP information will be configured on
initial boot. This means that if you have configured your DHCP
server with the desired information, you may connect your
Document Centre to your network and go right to the section
entitled Go to the Server/Workstation and....
For information on how your printer can connect to a BOOTP
server, or a RARP server to be assigned an IP address dynamically,
refer to the chapter in this document entitled Dynamic/Static IP
Addresses & WINS. Information in regards to static IP address
configuration may be found within that section as well.
To enable 100BaseT or a Token Ring interface, refer to Chapter 2
How to Connect to Ethernet or Token Ring Networks to
configure the Speed and Source Routing settings for your
environment.