Xerox Document Centre 480 ST, System Administration Manual

Page: 110 / 322

Page 16 - 4 Xerox Document Centre System Administration Guide
Before You Start
Your Document Centre device and workstation(s)
must be connected to a network which has the TCP/IP
protocol enabled.
This procedure assumes you have a general
knowledge of your network type and the operation of
your Web Browser software, and that your Document
Centre printer has been assigned all TCP/IP
information.
Configure your printer
NOTE To use Internet Services on the Document Centre
490/480/470/460 ST, this feature must be enabled.
The procedure below is supplied to enable this feature
or disable it if you do not wish to use Internet
Services.
1. Connect your Document Centre to the network
with the appropriate cabling.
2. Go to the Document Centre control panel.
3. Enter the Tools pathway.
a) Press the Access ( or ) button.
b) On the keypad enter 1111 or the current
password. Press the Enter button when
finished. The Touch Screen will be used
for the remainder of the data entry, unless
instructed otherwise.
c) Press the Go to Tools button.
4. Enable the Network Protocol.
a) Wait for the screen to refresh and press the
Connectivity and Network Setup button.