Xante PlateMaker 3, Manual

Page: 166 / 298

5-26 Ethernet Setup bb ______________________________________
Set the TCP/IP Address
Your printer’s default TCP/IP address should be changed to agree
with your network’s TCP/IP addresses. Change it using XANTÉ
Command Center or the front panel I/F:IP Address menu. Check
with your System Supervisor for the correct TCP/IP address.
See chapter 3 (Macintosh) or 4 (PC) to install and configure
Command Center on your host computer.
Note: If you perform a factory reset, the TCP/IP address reverts to
the XANTÉ factory default address.
Using XANTÉ Command Center (PC)
Note: Your PC must be directly connected to the printer through a
parallel or serial cable to use XANTÉ Command Center.
You cannot set the commands through a network.
1. If necessary, enable the Line Printer interface using printer
front panel menus. See “Interface Control” in chapter 6.
2. Open XANTÉ Command Center by double-clicking its icon.
3. Choose Controller: General: TCP/IP Address.
Fig. 5.20 PC TCP/IP Address Window
4. If necessary (check with your System Supervisor), change the
network class by clicking the appropriate option button.