Page 50
Integrated Modules
Integrated Modules
Component Removal
3-18
#826498 - Revision B - December, 2016
Electrode
To remove the electrode, first remove the bottom base
enclosure, then (See Figure 3-34):
Remove the electrode wire from the electrode.
1.
Use a 18 mm open end wrench or crescent wrench
2.
to remove the hex nut from the electrode mount.
Pull the electrode mount and electrode up through
3.
the pan.
Pan
To replace the pan, first remove the bottom base
1.
enclosure, then:
Remove the venturi/elbow assembly.
2.
Remove the regulator.
3.
Remove the gas valve/display board assembly, and
4.
the electrode.
Extract the top two screws from the front panel and
5.
remove the entire frame assembly.
Figure 3-34. Electrode
Electrode
Electrode
Mount
Bushing
Spring
Hex Nut
