Wilo DD-I, Installation And Operating Instructions Manual

Page: 167 / 196

Appendix en
Installation and operating instructions Wilo DD-I 167
Explanations for individual parameter groups in the system mode DDI, LPI and LSI
(Slave)
ƒ
Parameter group Status
Includes information on operating status, warnings and alarms.
ƒ
Parameter group Motor Information
Includes information about motor ratings, motor and hydraulic type, pump serial
number as well as minimum and maximum frequency.
ƒ
Parameter group Sensor Locations/Types
Contains information about the sensor types (temperature, current and vibration)
and their installation.
ƒ
Parameter group Data Readouts
Contains the current sensor values, operating hours, pump and cleaning cycles as
well as the energy consumption of the pump.
ƒ
Parameter group Time
Contains information about the date and time.
ƒ
Parameter group Control Word
Contains the settings of the pump operation mode, setpoint frequency, ramp times,
pump enable and pump functions.
ƒ
Parameter group Sensor Trip/Warning
Contains the threshold settings for the temperature and vibration sensors.
Explanations for individual parameter groups in the system mode LSI (Master)
ƒ
Parameter group System Variables
Includes information on system operating status, system warnings and system
alarms.
ƒ
Parameter group Analog Variables
Contains the current fill level values, pressure and flow as well as the frequency and
number of running pumps in the system.
ƒ
Parameter group Data Time Variables
Contains information about the date and time.
ƒ
Parameter group Pump 1 ... Pump 4
Contains information about the individual pump: Serial number, motor and hydraulic
type, status, warnings, alarms, current performance, operating hours, number of
pump and cleaning cycles, kWh counter.
ƒ
Parameter group Control Word
Includes the releases for PID control, for draining the tank and for the alternative
start level.
ƒ
Parameter group Modes
Contains the settings of the system operating mode and the control mode in auto-
matic mode.
ƒ
Parameter group PID Setpoint
Contains the setting for the PID setpoint.
See also
2 ModBus TCP: DDI/LPI/LSI Slave-Parameter [ } 168]
2 OPC-UA: DDI/LPI/LSI Slave-Parameter [ } 173]
2 ModBus TCP: LSI Master-Parameter [ } 178]
2 OPC-UA: LSI Master-Parameter [ } 182]