Wilo DD-I, Installation And Operating Instructions Manual

Page: 147 / 196

Configuration en
Installation and operating instructions Wilo DD-I 147
6.5.8.2 Changeable Warnings
The following priority settings can be assigned to the warning messages shown:
ƒ
Warning Type C: These warnings can switch a relay output on the frequency con-
verter or of the I/O module.
ƒ
Warning Type D: These warnings are only displayed and logged.
6.6 Function modules
Functional overview depending on the system mode.
Function modules System mode
DDI LPI LSI Master LSI Slave
Pump Kick
− • − •
Emerged Operation
− • − •
Operating Mode (Pump)
− • − •
Clog Detection
− • − •
Anti-Clogging Sequence
− • − •
Operating Mode (System)
− − • −
System Limits
− − • −
Level Controller
− − • −
PID Controller
− − • −
High Efficiency(HE) Controller
− − • −
Key
− = Not available, • = Available
6.6.1 Pump Kick
Periodic pump operation is possible to prevent prolonged pump standstill.
ƒ
Enable
Switch function on and off.
Factory setting: Off
ƒ
End time and Begin time
Periodic pump operation is not enforced outside this period.
Factory setting: 00:00
Input: hh:mm
ƒ
Motor Frequency
Operating frequency for periodic pump operation.
Factory setting: 35 Hz
Input: 25 Hz to max. frequency according to the rating plate
ƒ
Time Interval
Permissible standstill time between two periodic pump operation cycles.
Factory setting: 24 h
Input: 0 to 99 h.
ƒ
Pump Runtime
Running time of the pump during periodic pump operation.
Factory setting: 10 s
Input: 0 to 30 s