Wilo DD-I, Installation And Operating Instructions Manual

Page: 144 / 196

en Configuration
144 WILO SE 2020-12
Factory setting: Not In Use
Input:
–
Frequency
Current actual frequency output.
–
Level
Current fill level output.
NOTICE! For output, connect a corresponding signal
transmitter to an input!
–
Pressure
Current operating pressure output.
NOTICE! For output, connect a correspond-
ing signal transmitter to an input!
–
Flow
Display of the current flow quantity.
NOTICE! For output, connect a correspond-
ing signal transmitter to an input!
ƒ
Output 42 Type
Factory setting: 4...20 mA
Input:
–
0...20 mA
–
4...20 mA
ƒ
Output 42 Scale Max
Factory setting: 1
Input: Maximum value as real numerical value without unit or delimiters for decimal
places: Point
6.5.7 I/O Extension
Basic I/O module settings (input/output extensions):
ƒ
IP / Type Select
Settings for communication with the I/O module
ƒ
Digital Inputs
Digital input configuration.
ƒ
Analog Inputs
Configuration of the analogue inputs (only available in Wilo I/O 2).
ƒ
Relay Outputs
Configuration of the relay outputs. The number of outputs depends on the selected
I/O module.
6.5.7.1 IP / Type Select
Basic setting for the communication between pump and I/O module.
ƒ
Enable I/O Extension
Switch function on/off.
Factory setting: Off
ƒ
IP Address
IP address of the I/O module.
ƒ
Type Select
Select I/O module.
Factory setting: Wilo IO 1
Input: Wilo IO 1 (ET-7060), Wilo IO 2 (ET-7002)
6.5.7.2 Digital Inputs
Assigning the available functions to the relevant inputs. The name of the input termin-
als matches the name on the I/O module. Available functions can be freely assigned for
the following inputs:
ƒ
Input 1 Function
ƒ
Input 2 Function
ƒ
Input 3 Function
ƒ
Input 4 Function
ƒ
Input 5 Function
ƒ
Input 6 Function
Factory setting: Not In Use
Input:
NOTICE! In LPI system mode, the functions on the I/O module are the same as on
the frequency converter. The following description addresses the LSI system
mode.
–
High Water