Wilan LIBRA 5800 AP, User Manual

Page: 60 / 156

Configuration
60 Libra 5800 Series User Guide
System Commands
Master image files contain the software that runs the Libra. When a master image is rebooted, the
unit copies the MPC CPU code out of the master image in memory and runs it. It will also use the
DSP and FPGA code from the master image to boot those devices. If the master image also contains
a newer version of the BootROM code this will be updated as well.
When you first power up the unit, it runs from the default image loaded in at the factory. With the
System Commands menu you can control which master image file a unit uses to power up, and
which master image file a unit uses to reboot. These are typically the same except in the case where
you want to test an image before setting it as the default.
Note: Wi-LAN will make new images available on its website as they are developed.
Setting Default System Image
The default master image is the file used at power up. If you have more than one image saved on a
unit, you can change the default image. This default image is displayed in the System Revision
Information screen.
➧
To set the default image
1. From the Main System Menu, select
System Commands
and press
Enter
.
The System Commands menu appears.
2. Select
Set Default System Image
. The field highlights.
3. Press the up and down arrows to select the default image and press Enter . The new image file
will be used each time the Libra 5800 unit is powered up.
Reboot Current Image
Always use the
Reboot Current Image
command when the IP address changes or any other
parameter that requires an unit reboot to take effect. See Setting the Internet IP Address , page 64 .
System Commands
Set Default System Image lib5800-3-2-0.wil
Reboot Current Image Press Enter to Execute
Reboot a System Image lib5800-3-2-1.wil
Restore Factory Configuration Press Enter to Execute
Restore Poweron Configuration Press Enter to Execute
Reset MAC Layer Statistics Press Enter to Execute