Wilan LIBRA 5800 AP, User Manual

Page: 104 / 156

Appendix A: Upgrading Software
104 Libra 5800 Series User Guide
5. On the Libra unit, type
dir
and press Enter to list the file/s existing on the unit.
6. Ensure that there is enough free space to hold the new Master Image file. If there is not, the files
that are not protected (protected files are identified by "PR") can be deleted using the "del"
command. Any files in use by the unit are always protected. Unused files will be listed as "read/
write" (RW), "read only" (RO), or "write only" (WO).
7. On the PC, type
ftp <IP address>
and press Enter , where the <IP address> is the IP
address of the Libra AP. The PC connects to the AP.
Note: ftp must be installed on your PC.
8. Type “
ofdm”
and press the Enter key. The password prompt appears.
9. Type “
supervisor”
for the password and press Enter. (Supervisor access is required to
change unit settings–see Setting Menu Passwords , page 53). The
ftp>
prompt appears.
10. After the ftp prompt, type the following “put” command.
Note: Leave a single space after “put”.
where
. Current directory that contains the image file (for example,
c:
\projects\wib\current\bin
)
<image filename> Name of the Master Image file
c:\projects\wib\current\bin> ftp 192.168.3.85
Connected to 192.168.3.85
220 Wi-LAN xxxx OFDM Ethernet Bridge FTP Server
User (192.168.3.85(none)):
This IP address is an example only.
Enter the IP address of your AP in P-MP network or the
Base in P-P network.
ftp> put .\<image filename>