Configuration
34
Unit Configuration:
Setting the RF Station ID
Each Libra unit requires a unique RF Station ID to identify it on the network. Every unit must have a
unique RF Station ID. No two units may have the same ID. In a P-P system you cannot access this
selection.
➧
To set the RF station ID
1. Select
RF Station Id [1..2047]
and press
Enter
. The entry field highlights.
2. Type a unique number for the RF Station ID and press
Enter
. Zero is not a valid Station ID.
3. Record the RF Station ID you have assigned to the unit.You will need to know this number when
you configure the polling list on the Access Point.
4. Reboot the system to effect the changes unless there are more changes you would like to make
at this time. To do this move the cursor down to the line, "Activate changes and reboot" and press
Enter
Setting the Sector ID
Each Libra unit can have a Sector ID to identify its AP within the cell on the network. This prevents
Libra units from accessing different APs which may have the same Center Frequency.
➧
To set the Sector ID
1. Move the cursor to the
Sector Id [0..31]
field and press
Enter
. The entry field highlights.
2. Type a unique number for the Sector ID and press
Enter
.
3. Reboot the system to effect the changes unless there are more changes you would like to make
at this time. To do this move the cursor down to the line, "Activate changes and reboot" and press
Enter
Setting the Synchronization ID
Because of OFDM’s superior multipath performance it is possible for the Libra to falsely synchronize
on an AP from a different sector operating at the same frequency. In order to avoid this type of error,
the APs and Libras of each sector can have one of two possible OFDM synchronization patterns.
These patterns are orthogonal, thus a Libra with a given Synchronization ID will never synch to an
AP with the other synch. Every Libra in the sector must have the same Synchronization ID as the AP
of that sector.
➧
To set the Synchronization ID
1. Move the cursor to the
Synchronization Id [0..1]
field and press
Enter
. The entry field
highlights.
2. Type a 0 or 1 to select the Synchronization ID and press
Enter
. Factory default is zero (0).
3. Reboot the system to effect the changes unless there are more changes you would like to make
at this time. To do this move the cursor down to the line, "Activate changes and reboot" and press
Enter
. Setting the Modulation Type
Summary of Contents for LIBRA 5800 AP
