Wilan LIBRA 5800 AP, User Manual

Page: 39 / 156

PDA Setup Menu
June 2003 Rev 0 39
PDA Setup Menu
When logging into the unit using the PDA login, it will come up in setup mode. This is in the form of
two screens that display all of the parameters that the user needs to set up the unit and get it talking
with the base station.
Many of the fields on this menu can be found in more detailed menus available when using a PC as
discussed later on in this section.
Unit Configuration:
Setting the RF Station ID
Each Libra unit in a P-MP network requires a unique RF Station ID to identify it on the network. Every
unit must have a unique RF Station ID. No two units may have the same ID. In P-P system you
cannot access this selection.
➧
To set the RF station ID
1. Select
RF Station Id [1..2048]
and press Enter . The entry field highlights.
2. Type a unique number for the RF Station ID and press Enter . Zero is not a valid Station ID.
3. Record the RF Station ID you have assigned to the unit.You will need to know this number when
you configure the polling list on the Access Point.
4. Reboot the system to effect the changes unless there are more changes you would like to make
at this time. To do this move the cursor down to the line, "Activate changes and reboot" and press
Enter
Libra Setup
RF Station Id [1..2048] -> 244
Sector Id [0..31] 7
Synchronization Id [0..1] 0
Modulation Type QAM 16
Tx Power [-14..17] 17
Rx Center Freq (kHz) 5787000
Tx Center Freq (kHz) 5787000
Internet IP Address 192.168.1.100
System Ethernet Access on
Local Network Mac Filter off
Monitor Screen Logout
Activate changes and reboot