Wilan LIBRA 5800 AP, User Manual

Page: 127 / 156

Configuring the units
June 2003 Rev 0 127
Configuring the units
This section describes how to set intitial AP and CPE (for P-MP) parameters or base and remote (for
P-P) parameters so you can perform bench tests. See
Configuration, page 27 for detailed
instructions about setting parameters.
➧
Hookup to Configure the Libra
1. Connect a PC or PDA to the serial port of the Libra using a straight-through (for PC) RS-232
cable
RS-232 Connection
Configuring a P-MP System
Configuring an AP
When you configure an AP, you will need to perform the following tasks.
• Set an RF Station ID
• Set RF Center Frequencies
• Set the Sector ID
• Set the Synch ID
• Choose the Tx Power
• Add the CPE to the polling list
Configuring a CPE
When you configure a CPE, you will need to perform the following tasks.
Libra Unit
PC
RS-232 Serial Cable
to PC COM port
Serial Port
Detail
Libra
Serial Port
DB9
(female)
Libra
Serial cable