Wilan LIBRA 5800 AP, User Manual

Page: 33 / 156

Quick-Start Menu
June 2003 Rev 0 33
Quick-Start Menu
When the Libra unit starts up for the very first time, it will start up in setup mode. This a single screen
as shown below that displays all of the parameters that the user needs to set up the unit and get it
talking with the base station.
Many of the fields on this menu can be found in more detailed menus as discussed later on in this
section.
Exiting Setup
When the setup procedure is complete and the unit has been re-booted to activate all the changes
you can exit the setup procedure.
➧
To exit setup
1.
Move the cursor to the
Exit setup and logout
field and press
Enter.
Libra Model 5800 - 12.5 MHz Setup Menu
Unit Configuration Communication Parameters
RF Station Id [1..2048] -> 2 Internet IP Address 192.168.1.100
Sector Id [0..31] 1 Internet IP Mask 255.255.255.0
Synchronization Id [0..1] 0 System Ethernet Access on
Local Network Mac Filter off
Radio Configuration Access Configuration
Modulation Type QAM 16 SNMP Priv Community netman
Tx Power [-14..17] 17 Super Password Press Enter to change pwd
Rx Center Freq (kHz) 5787000 Confirm Super Pwd Press Enter to confirm pwd
Tx Center Freq (kHz) 5787000 User Pwd Press Enter to change pwd
Confirm User Pwd Press Enter to confirm pwd
OFDM Channel Statistics PDA Password Press Enter to change pwd
RSSI (dBm) -22 Confirm PDA Pwd Press Enter to confirm pwd
Null Depth (dB) 0
Fade Margin (dB) 53 Link Test
RF Link Status Not Connected Link Test Type Coarse (xE-5)
Dest Radio Id [1..2048] 9
Start Link Test
Activate changes and reboot
Exit setup and logout