Configuration
64
Network Configuration
To enable the Libra to communicate via TCP/IP you need to assign an Internet IP address and IP
mask.
Note: The menu shown here is the one for the CPE or LCPE (in a P-MP system) and the remote in a
P-P system. The only difference for AP and base station is that VLAN tagging entries do not
appear.
Setting the Internet IP Address
An IP address must be assigned to each Libra unit in the network. Changes takes effect on the next
reset. You will require the IP address of your Libra unit for this procedure. Your system administrator
should be able to provide it.
➧
To set the Internet IP address
1. From the Main System Menu, select
Network Configuration
and press
Enter
.
The Network Configuration menu appears.
2. Select
Internet IP Address
and press
Enter
. The data entry field highlights.
3. Type the unique Internet IP address for the unit and press
Enter
. The Internet IP address is
assigned to the unit.
4. Reboot the current image to make changes take effect. See
Important
When you change the IP address, you must reboot the current image for the
changes to take effect. See
,
for more information.
Summary of Contents for LIBRA 5800 AP
