Waves HPSA-7100-R Series, Installation And User Manual

Page: 45 / 179

HPSA-7100-R Series Installation and User Manual 19
P/N P01- 04946 Rev C
Installing the Speaker Array
FIGURE 3.2
Attach the Driver to the Speaker
5. Prior to inserting the drivers and attaching the covers, insert the provided hexagon
head bolts required for tightening the drivers around the pole. Follow the bolt
directions as show in Figure 3.6 and Figure 3.8. The bolts will remain loose until
the drivers are properly positioned and tightened onto the pole.
6. Carefully screw the speaker driver into the speaker until hand-tight. Ensure the
driver drain hole is at the bottom and the quick connects are not bound or pinched.
7. Minimize unwanted pressure and torque on the connectors by making one twist of
the speaker wire loop and wrap around each of the drivers. Ensure the loop fits
inside the driver cover.
8. If not already done, attach the quick connect to each of the driver terminals as
described in Step 2. Ensure these connections are tight for a proper connection.
FIGURE 3.3 Attaching the Quick Connect to the Speaker Driver
The mounting bolts must be installed before the drivers and covers are
mounted and installed. Verify the length of the hexagon bolts is appropriate
for the diameter of the pole; replace provided bolts with (installer provided)
shorter or longer hexagon bolts if necessary.
Turn the speaker driver until hand- tight (snug - do not over tighten) and
the drain hole is at the bottom. Failure to properly position the drain
hole may result in water build-up and equipment damage.