Waves HPSA-7100-R Series, Installation And User Manual

Page: 113 / 179

HPSA-7100-R Series Installation and User Manual 87
P/N P01- 04946 Rev C
CHAPTER 8
Using the HPSA-7100-R
The HPSA-7100-R allows trained service personnel to monitor and activate tones and live
test messages locally from the unit as well as configure settings and gather diagnostic data.
This chapter describes the steps trained service personnel are expected to understand and
implement for utilization of the HPSA-7100-R, monitoring the unit, responding to alerts,
configuring settings from the Control Panel and gathering diagnostic data.
The following section is included in this chapter:
•
Working with the HPSA-7100-R
•
Gathering HPSA-7100-R Information
8.1 WORKING WITH THE HPSA-7100-R
The HPSA-7100-R provides the capability to broadcast tones directly from the HPSA-
7100-R for setup and testing. The sections below describe how to access stored tones.
8.1.1 Using the Communications Panels
For instructions on using the communications panels, refer to Chapter 7, Section 7.3.1,
Using the Communications Panels for detailed descriptions.
8.1.2 Adjusting the HPSA-7100-R Master Volume
The HPSA-7100-R’s Master Volume can be lowered temporarily for testing purposes
only. If the volume is set too low, the Amp Fault Trouble LED illuminates. Ensure the
Master Volume is set to its original setting when testing has completed.
1. From the HPSA-7100-R’s Control Panel, press the down arrow, select Adjust
Volume and then press ENTER . The LCD screen changes to Setting HPSA
Master Volume .
2. Perform the following until the volume is set as desired:
The Master volume can be set to between 0 and 1023, which is the factory-
set value of the Master Limit (MstrLim).