Waves HPSA-7100-R Series, Installation And User Manual

Page: 94 / 179

Activating the HPSA-7100-R
68 HPSA-7100-R Series Installation and User Manual
P/N P01- 04946 Rev C
shown below in Figure 7.9.
FIGURE 7.9
HPSA Control Panel
2. Press the V key on the laptop’s keyboard; the Volume Control Utility will open
in the session window as shown in Figure 7.10, defaulting to the Master setting.
FIGURE 7.10 Adjusting the Master Setting Using HyperTerminal
3. Press the P key on the laptop’s keyboard to cycle through the various volume
level settings; stop and familiarize yourself with the three settings used when
setting the HPSA’s Volume Control as follows:
a. Stop at [Master] Figure 7.10 above, identifies the Master setting,
which will be
verified or adjusted in
Section 7.2.3.1.
b. Stop at [Line In][Left] : Figure 7.11 identifies the Line-In setting, which will be
verified or adjusted in
Section 7.2.3.1.
When the Control Panel screen is on the Main Menu, HyperTerminal is
activated for changing settings. If the Control Panel is not on the Main
Menu, HyperTerminal will default to the Master setting as indicated in
Figure 7.11 and will not accept selection commands.