G413 User Guide Document: G41302
-------------------------------------------------------------------------------------------------------------------------------------------
29
11.2.2 Setup procedures
Follow the instruction in Preset Mode 18 to do signal connection in both G413. One G413 control
left four LCD and another one controls right four LCD.
Global Video Wall settings in G413-A
Activate OSD
[Video Wall]
[Zoom] H=2, V=1
[Pan] H=1, V=1
Global Video Wall settings in G413-B
Activate OSD
[Video Wall]
[Zoom] H=2, V=1
[Pan] H=2, V=1
Video Wall [Position] settings:
When use Zoom function to split the image, it will cut the image from middle. Actually G413-A &
G413-B images has some overlap. Therefore, user needs to crop more pixels for G413-A in LH
side and G413-B in RH side.
Based on the panel arrangement, the overlap is about 11.5% in horizontal direction. If the input
is 3840*2160, estimated [Position] moving pixel as follows: 3840*11.5%/2=221 pixels.
Activate OSD
[Video Wall]
[Overlap]
Select G413-A Right Edge/G413-B Left Edge and
set value at +221. The value in two G413 should be the same to get the same scaling factor.
Fine-tune image position may be required through the same procedures as that in single unit
application by Galign2 PC Tool or remote controller.
11.2.3 Multiple contents display in cascaded video wall
User can select different input sources for Display Unit A & B and set video wall [Zoom] H=1, V=1
in both G413 to display different contents in the video wall. It can be saved into another Profile
[Index]. User can switch between different display modes to show different display style in the
video wall.
User can use PIP/POP function to add more display content in each G413. In this case, the
maximum display contents will be up to 4 in the above video wall.
A
A
B
B
