G413 User Guide Document: G41302
-------------------------------------------------------------------------------------------------------------------------------------------
22
(16)
[Loop Range]:
-
[Loop Range] is to select display Mode # for looping playback.
-
It will start from Mode #1. If user selects [5], it means the system will execute looping playback for
Mode #1 to Mode #5.
-
The display Modes for looping playback shall be continuous. User needs to arrange the sequence of
the display Modes in advance.
(17)
: [Loop Time]:
-
[Loop Time] is to set the time interval from one display Mode to next display Mode in looping
playback. If user wants to display specific display Mode with double time, user can save the same
setting in the next display Mode and put it into Loop Range.
(18)
[Reset]:
-
[Reset] is to reset selected display Mode to default value and let GeoBox to show source image on
each LCD. It will be convenient when user wants to see full image for some operations.
-
This Reset function will only apply to single display mode.
-
User can also use [Reset] hotkey on the bottom of remote controller for complete system reset. It will
reset all custom settings in G413 except the setting saved in Profile Index. Here is the process:
--Reset All settings: [Reset]
click [Right direction key]
Enter.
--Reset [Video wall setting]: Reset
click [Left direction key]
Enter.
(19)
IP address setting:
-
User can execute IP address setting from remote controller OSD menu, WebGui or Galign2.
-
If multiple units are used at the same time and setup by Ethernet, user can set different IP address
for each unit so that user can use one PC to control all units at the same time.
(20)
[Firmware update]:
-
User can update both Firmware and MCU Code through this function.
-
No update sequence between Firmware and MCU code.
-
The system will recognize the type of the software and install to the system automatically.
(21)
Browser the file for code update
-
If the file is compressed, please decompress to .bin file for execution.
(22)
[Start]:
-
After select the .bin file for code update, click [Start], the system will start to update the code.
(23)
Finish Code update:
-
It will take about 70 seconds to finish FW update process.
-
[Process Done] window will show up. Click [OK] to finish code update process.
PS. After finish code update, please insert small pin into RESET hole of back panel for 5 seconds to reset
the system again. It will remove all previous settings into default value, including all settings in display Modes
and Profile Indexes. If user doesn’t like to remove old settings, this process can be neglected and if user
