G413 User Guide Document: G41302
-------------------------------------------------------------------------------------------------------------------------------------------
11
7 Preset Display Modes
7.1
Introduction
LCD panel used in Preset Mode must have the same size and 16:9 aspect ratio.
Preset mode doesn’t take LCD panel bezel size into consideration. It is good for slim bezel under
3.5mm active to active bezel size. If the bezel is larger, user may need to do further bezel
correction through position fine-tune in each LCD.
If the preset mode with LCD at 0/90/180/270 degrees, it will be less sensitive to bezel size. User
will still see acceptable video quality even the bezel is up to 5-10mm width.
The preset modes will fit complete source image with full screen across entire video wall. It will
not consider the aspect ratio of the signal source.
User can also use [Overlap] function under [Video Wall] menu to adjust the cropping area of the
signal source for entire video wall.
User can use [Ratio] & [Position] OSD menu to adjust final aspect ratio and position in the video
wall based on the image that is cropped through [Overlap] function.
Customized Mode can be created with all kind of LCD without size and bezel limitations.
7.2
LCD (TV) selection for Preset Mode
Type of LCD: low cost 16:9 LCD or TV can be used. No need to have matrix control feature.
All the LCD panels used in the same video wall must have the same size and 16:9 aspect ratio.
Some Display Modes support TV at top down flip position to balance the bezel difference.
Output resolution: the default output resolution is 1920x1080 @60Hz in each output channel. The
LCD must be able to support FHD input timing.
7.3
Select Preset Display Modes through OSD
