G413 User Guide Document: G41302
-------------------------------------------------------------------------------------------------------------------------------------------
21
(8)
[Shift Mode]:
-
After check [Shift Mode], user can change [Top Left] X&Y value to shift image position in H&V
directions for each TV without changing the image size and angle. Each channel is independent.
-
While executing [shift] function, X&Y values must be also in the range 0-1920 for X direction and 0-
1080 for Y direction.
(9)
[Warp Ratio]:
-
[Warp Ratio] will apply to all channels at the same time to enlarge or shrink complete video wall image
in H&V direction from a range 25% to 200%.
-
All Preset Modes will show entire source content. If the video wall in not 16:9 aspect ratio, [Warp
Ratio] has been applied to Preset Mode to show entire image in the video wall.
-
User can change [Warp Ratio] to change cropping area or change aspect ratio.
-
The result will not be showed in [Diagram].
(10)
[Warp Position]:
-
When the video wall has applied [Warp Ratio], user can shift complete video wall image position by
[Warp Position].
-
The adjusting range for [Warp Position] is followed the percentage in [Warp Ratio]. If user didn’t adjust
[Warp Ratio] (value is 100), then no [Warp Position] adjustment is allowed.
(11)
[Mode #]:
-
Mode # is the location to save parameters created in Galign2. It doesn’t include other settings that is
not inside Galign2, such as input selection, PIP or EDID setting.
-
User saves up to 10 modes and executes seamless looping playback to show special effect for the
video wall.
-
[Write] command is to save Galign2 settings into display Mode.
-
When user click Mode #, then click [Write], it will erase original setting and replace with new
parameters in each TV. If user click [Read], then click [Write], it will upload the settings in that Mode #
to the video wall and user will see the final result.
(12)
Profile [Save]:
-
After select Profile index # (1-5), user can save the final settings to G413 together with other settings
from Remote controller, such as input source, PIP/POP, video wall settings, color, EDID...
-
Please select one Index #, then click [Save] to save the setting. The result is the same as Profile
Save executing from remote controller.
-
All channels will be saved at the same time. Maximum 5 Profile Indexes can be saved and recalled.
(13)
Profile [Load]:
-
User can load back Profile settings and execute further editing.
(14)
[Save Setting] in PC:
-
User can save Galign2 settings in PC as a backup or copy to other G413 through [Save Setting].
(15)
[Load Setting] from PC:
-
User can load Galign2 settings from [Save Setting] command and execute further editing.
