VIDAR CAD PRO Advantage, Installation And Operation Manual

Page: 54 / 144

49
If necessary, terminate the SCSI bus
The film digitizer has a single SCSI port connector, and must be
connected directly to the computer or connected at the end of a SCSI
chain. In this configuration, the digitizer must provide termination for
the SCSI bus. The digitizer was set for SCSI bus termination at the
factory.
VIDAR strongly recommends that you not change the
factory SCSI termination setting.
Note: If you cannot install the digitizer at the end of a SCSI
chain, please contact VIDAR Technical Support for instructions
(+1.703.471.7070 or medtech@vidar.com).
Note: When the film digitizer is at the end of the SCSI chain,
the SCSI termination switch must be set for SCSI termination .
Consult your SCSI controller manual regarding proper use of
termination.
If you determine that the film digitizer’s SCSI termination is not set for
internal termination (left picture below), here is how to change the
setting to deactivate internal termination:
1. Locate the SCSI termination switches on the back of the digitizer.
2. Push both switches as shown below.
Factory (recommended)
termination switch setting Not recommended
Switches
pushed
this way Switches
pushed
this way
VIDAR Advantage Series Installation and Operation Guide