VIDAR CAD PRO Advantage, Installation And Operation Manual

Page: 104 / 144

99
Cleaning the Auto-Feed Roller and Suction Cups
[C
AD
P
RO
™ Advantage only]
After extensive use, dust or lint particles may build up on the Auto-Feed
Roller and Suction Cups, and they must be cleaned to maintain reliable
film feeding. VIDAR recommends cleaning the Auto-Feed Roller and
Suction Cups at least twice per year. During cleaning, inspect the
Suction Cups for wear.
1. Turn off the digitizer using the switch on the rear panel.
2. Remove the Film Guide from the feeder by loosening four screws.
Loosen each screw a few turns, then move to the next screw. Repeat
until the Film Guide is freed from the feeder.
Note: The screws are captive, but will come entirely out if
unscrewed too far, and could then fall into the digitizer base. Be
careful not to unscrew them from their captive locations.
Removal of screws or other items from the inside of the digitizer
is not covered under your warranty.
Auto-Feed Roller
Captive screws Captive screws
Film Guide
VIDAR Advantage Series Installation and Operation Guide