VIDAR CAD PRO Advantage, Installation And Operation Manual

Page: 53 / 144

48
If necessary, set the digitizer’s SCSI ID
A computer equipped with a SCSI bus can communicate with multiple
SCSI devices (for example: a film digitizer, a scanner and a disk drive).
Each device must have a unique SCSI ID number so the computer can
distinguish it from other SCSI devices. Valid SCSI ID numbers range
from 1 to 6.
When selecting SCSI ID numbers:
The SCSI Card 2930U is preset to SCSI ID 7 and should not be
changed.
Set the film digitizer to any SCSI ID between 1 and 6, as long as that
number is not used by another SCSI device attached to the computer.
Note: The digitizer is shipped from the factory with the SCSI
ID preset to 3.
If the system is configured to boot from a SCSI disk drive, it’s best to
set the disk’s SCSI ID to 0 or 1. Most SCSI disks are preset to SCSI
ID 0 at the factory.
CAUTION: The digitizer and computer MUST be turned OFF
before changing the SCSI ID.
To set the digitizer’s SCSI ID:
1. Locate the SCSI ID switch on the back of the
digitizer below the SCSI port connector.
2. Change the SCSI ID switch using a 1/8" or #2
flat blade screwdriver.
Note: Do not set the switch to 0 , 7 , 8 , 9 , A , B , C , D or F .
CAUTION: Do not force switch rotation. Do not use a large
screwdriver to rotate the switch.
VIDAR Advantage Series Installation and Operation Guide