504PRO_604PRO_o-m2_00
-
504/604 PRO Baler
Preparing the Equipment Baler 7-29
4. Press softkey (D) to enable the cutting device circuit.
5. Press softkeys (A), (G), and (H) to select desired knife group.
6. Move tractor hydraulic control in the opposite direction that lowered the bottom door in Step 2.
•
The selected knife group raises into cutting position through bottom door. Knife motion should be visible from the operator station.
Bottom door raises and closes fully.
•
Keep tractor hydraulics engaged until icon (K) turns on.
Icon (K) indicates knife circuit accumulators are fully charged to 580 psi (40 bar). If knife circuit accumulators are not fully charged, knives
may gradually lower during operation reducing their effectiveness.
Note that if icon (K) appears but icons (I) do not indicate knives engaged, it is likely that knives are blocked by debris and cannot push
through to fully engaged position. Refer to High-Pressure Override procedure below.
7. Press softkey (J) to return to home screen.
8. Baler is ready to operate when icon (B) indicates a knife group engaged and icon (C) indicates bottom door is fully raised.
9. Press softkey (F) to select pickup circuit.
10.Place tractor hydraulic control in FLOAT position and begin baling.
https://tractormanualz.com
Summary of Contents for 504 PRO
Page 153: ...https tractormanualz com ...
