504PRO_604PRO_o-m2_00
-
7-10 Preparing the Equipment Baler
504/604 PRO Baler
•
Lift driveline [4] from holder [3](see Figure 32 on page 7-10).
•
Align splines and push driveline onto tractor PTO shaft.
•
Pull back on collar [6], push driveline onto tractor shaft, and release collar (see Figure 33 on page 7-10). Push onto tractor shaft until collar snaps
into locked position. Pull back on driveline to ensure it is properly locked in place.
•
Install and lower tractor PTO shield [5] (see Figure 33 on page 7-10).
•
Connect anti-rotation chain [7] (if equipped) to tractor (see Figure 34 on page 7-11).
Figure 32. Lift driveline
Figure 33. Driveline
—
couple to tractor
NOTICE
To prevent hose and cable damage, route all hoses and wiring harnesses through hose run [2]. When disconnected from
tractor, store all hoses and wiring harnesses in holder [1](see page 7-10).
7.4.2
Driveline
–
uncouple from tractor
•
Disconnect anti-rotation chain [7] (if equipped) from tractor (see Figure 34 on page 7-11).
•
Raise tractor PTO shield [5] (see Figure 33 on page 7-10).
•
Pull back on collar [6], pull back driveline off of tractor PTO shaft, and release collar (see Figure 33 on page 7-10).
https://tractormanualz.com
Summary of Contents for 504 PRO
Page 153: ...https tractormanualz com ...
