Utax P-4531DN, Operation Manual

Page: 169 / 352

4-91
Operation Panel
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the standard by the IETF for authentication and encryption in
the third network layer (IP layer).
It can be used with both IPv4 and IPv6.
1
In the
Basic
menu, press  or  to select
IPSec
.
2
Press [OK] . The
IPSec
screen appears.
3
Press

or

to select whether IPSec is enabled.
4
Press [OK] . The IPSec setting is set and the
Basic
menu reappears.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting is
Auto
.
1
In the
Basic
menu, press  or  to select
LAN Interface
.
2
Press [OK] . The
LAN Interface
screen appears.
The available LAN Interface are as follows:
Auto
10BASE-Half
10BASE-Full
100BASE-Half
100BASE-Full
1000BASE-T
3
Press

or

to select the desired LAN Interface.
4
Press [OK] . The LAN Interface is set and the
Basic
menu
reappears.
MACAddressFilter (MAC address filtering setting)
This sets whether or not to enable MAC address filtering.
1
In the
Basic
menu, press  or  to select
MACAddressFilter
.
2
Press [OK] . The
MACAddressFilter
screen appears.
3
Press  or  to select whether MAC address filtering is enabled.
Note
IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP addresses.
IPSec:
Off 01
On 02
*
Note
LAN Interface
is only displayed when the optional Network Interface Kit (IB-50) is installed.
LAN Interface:
Auto 01
10BASE-Half 02
*
10BASE-Full 03
Note
The detailed settings for MAC address filtering are selected using the optional Network Interface Kit utility
software.
MACAddressFilter:
Off
01
On
02
*