Ultrak JPD-100, User Manual

Page: 59 / 124

RUN VECTORSCAN
518007-1960-G 2-38 KEMU040018
January 2002
2.2.8.4 Run VectorScan
Enter the following command sequence at the controller to start a
programmed VectorScan on a SmartScan unit. The commands are in
bold typeface.
Enter the VectorScan #, then press VSCAN. # VSCAN
Example:
The controller display shows: CNTL - CAM 1 MON 1
(no secondary camera/monitor selected)
Start VectorScan 1 on Camera 1. Enter following command
sequence.
1 VSCAN
SmartScan unit one moves to the first PreShot listed in the VectorScan
and remains there for the specified dwell time. The title of the PreShot is
displayed on top of the monitor. If the Camera ID is enabled for the
SmartScan Unit, the Camera Number appears on the bottom of the
monitor with the letter A beside it for Automatic Operation.