Ultrak JPD-100, User Manual

Page: 65 / 124

TOURS
518007-1960-G 2-44 KEMU040018
January 2002
Perform the desired pan, tilt, and zoom commands. The maximum
programming time is two minutes (120 seconds). To end programming
before the unit times out, press 3 (END).
2.2.11.2 Run Tour
To start a programmed tour using the JPD-100 controller, perform the
following procedure.
Press OPT OPT
Press 1 (MISC) 1
Press 4 (TOUR ON) 4
TOUR ON activates function keys 5, 6, and 7 to run tours 1, 2, and 3,
respectively. Note: When function keys 5, 6, and 7 are activated to run
tours, the user programming for the function key is disabled. When the
function keys are deactivated, the user programming for the function key
is enabled. Refer to Section 3 of this manual for programming function
keys.
Press the function key for the corresponding tour . A tour runs until
stopped by a manual control command (pan, tilt, zoom, focus, iris) or
another automatic command (PreShot, VectorScan, or Tour).
To deactivate the function keys, press OPT > 1> 4 (TOUR OFF).